Skip to content

Gas Leak Detection Macquarie Hills

Gas leak detection in Macquarie Hills finds and fixes leaking gas lines, meter connections and appliance faults in homes across the hill. A licensed gas fitter arrives with a gas detector, narrows the leak to one fitting and prices the fix before touching it.

The crew behind your plumber in Macquarie Hills. We handle all the gas fitting on the hill, and a suspected leak is the call we treat as urgent. Here is what to check, how the trace runs, and what shapes the cost.

Get outside first. A strong smell indoors means no switches, no flames and everyone out to the street. Call the distributor's emergency number from outside, never from inside the house, and ring us when everyone is clear. The rest of this page covers smells that are suspicious rather than dangerous right now.

Licensed plumbers and gas fitters · NSW Lic. 359278C

Last updated September 2026

Gas fitter at work on a kitchen oven

Which Signs Point to a Gas Leak?

Gas leaves more clues than the smell alone, and a leak can run for weeks before anyone notices it. Any single clue on this list justifies booking a detection visit:

  • The rotten-egg odourant, even faint or on and off, indoors or by the meter
  • A hiss near the meter, along a pipe or at an appliance fitting
  • Yellow, floppy cooktop flames where they used to be crisp and blue
  • Garden plants dying off above a buried gas pipe
  • Feeling headachy or dizzy inside, then better out in the yard
  • Gas bills rising while your cooking and heating stay the same
Gas cooktop burner alight
Plumber beside a newly installed continuous-flow gas hot water unit

How We Trace and Repair the Leak

Every leak job runs the same sequence, whatever the appliance or the pipe involved:

  1. 1

    Isolate the supply

    We shut the supply at the meter first, so the line is dead while we trace.

  2. 2

    Trace it

    A gas detector runs along the pipe, through the sub-floor and around every fitting, until it settles on the exact point.

  3. 3

    Pressure test

    The suspect section is tested to prove the leak is there and nowhere else on the run.

  4. 4

    Repair and retest

    The joint or pipe is repaired or replaced, the whole line is pressure-tested once more, and the appliance is relit and commissioned.

If the fault is a worn-out appliance rather than the pipe, installing a replacement is the next step.

How Is a Gas Leak Call Priced?

A leak repair is priced on:

  • Location: meter, sub-floor or wall cavity
  • The pipe itself, since copper, polyethylene and galvanised steel are each joined differently
  • Access, meaning how much of the house sits between the gas fitter and the faulty section
  • Timing, since nights and weekends fall under the after-hours rate

Old Lines, Cold Slopes and Heating Season

The houses here went up in one push, and so did their gas work

Most homes on the hill are brick-veneer builds from the sixties to the eighties, and the gas lines, heater connections and meter runs from those years are now the oldest working parts of the house. Joints that have been through fifty Hunter winters are the first places the detector checks.

Winter puts those lines under load

The upper slopes catch chilly elevated nights, and the whole-home heating upgrades that come with the season mean heaters, and the lines feeding them, are running for months at a stretch. If a faint smell turns up on the first cold night of the year, get it traced early; a fix in May beats one in mid-July with the heater out of action.

What Customers Say

We had an urgent gas problem that required immediate attention at our home…on a Friday afternoon. … Identified the issue, fixed and tested
Lee

When We're Not the Right Call

A leak on the supply side of the meter belongs to the gas network, and the trace shows quickly if that is where it sits. From there the repair is theirs; ours is every pipe downstream to your appliances. An appliance still under manufacturer warranty is the other case, since a warranty claim needs their technician, not ours.

Gas Leak Questions From the Hill

What is the first thing to do when the house smells of gas?

Get everyone out to the footpath and leave every switch as it is on the way. Phone the distributor's emergency line once you are outside, not from indoors. When the house is clear, ring us to trace the leak and quote the repair.

Do you find and fix the leak on the same visit?

Where the failed joint is easy to reach, yes, it is repaired once you approve the price. Where the fault is in a line buried under a floor, the repair is quoted first and no work begins before you sign off.

Are gas leaks on Macquarie Hills blocks an after-hours job?

Yes, because a gas leak does not wait for business hours and winter on the hill keeps heaters working hard. Visits outside daytime hours carry the after-hours rate. It costs nothing to get us out to your door (excluding after-hours).

Can a leak be traced behind a brick-veneer wall without pulling it apart?

In most brick-veneer homes, yes. The detector and a pressure test pin the leak to one length of pipe first, and gas lines in these houses run mainly through the sub-floor rather than inside the walls. Brickwork is opened only where the trace proves it has to be.

Need a plumber? Call or send the form

Call (02) 4093 0558 or send the form below. Available 24/7, you see a fixed figure ahead of any work, and every job carries our 365-day warranty on all work.

Call (02) 4093 0558

Request a callback

Leave a name and number and a plumber will ring you back.

We use your details only to call you back about this job. See our privacy policy.

Call (02) 4093 0558 Get a quote